6) Gain Control
Use positions # 7 and # 8 on SW1 DIP switch on the rear panel.
7) Interlace system
Use
position # 5 on SW1 DIP switch on the rear panel.
MODE
INTERLACE
NON-INTERLACE
8) Gamma Correction
Use positions # 6 on SW1 DIP switch on the rear panel to set Gamma.
GAMMA=1.0
Note
Above switching is effective only for Video 1.
Gamma is fixed with 1.0 for Video 2.
RS-232C Communication Mode
Use positions #7 & #8 on
with RS-232C.
L
Note : Be sure to make the camera POWER OFF before the mode settings of Pos. #7
power ON to start the serial communication mode by RS-232C.
Any settings on SW1 on the rear panel will lose priority to the serial
communication mode by RS-232C, except Gamma ON/OFF setting at Pos. #6.
CV-M10
Pos. #5
OFF
ON
Pos.
I
OFF
SW1 DIP switch on the rear panel to control
Pos.
ON
- 18 -
(CV-M10RSE/RSC)
Pos. #8
I
ON
I
I