Danfoss VLT AutomationDrive FC 302 Operating Manual page 4

Contents
5.9 Control Wiring
6 Pre-start Check List
7 Commissioning
7.1 Applying Power
7.2 Programming the Drive
7.3 Testing Before System Start-up
7.4 System Start-up
7.5 Parameter Setting
8 Wiring Configuration Examples
8.1 Programming a Closed-loop Drive System
8.2 Wiring Configurations for Automatic Motor Adaptation (AMA)
8.3 Wiring Configurations for Analog Speed Reference
8.4 Wiring Configurations for Start/Stop
8.5 Wiring Configuration for an External Alarm Reset
8.6 Wiring Configuration for Speed Reference Using a Manual Potentiometer
8.7 Wiring Configuration for Speed Up/Speed Down
8.8 Wiring Configuration for RS485 Network Connection
8.9 Wiring Configuration for a Motor Thermistor
8.10 Wiring Configuration for a Relay Set-up with Smart Logic Control
8.11 Wiring Configuration for Mechanical Brake Control
8.12 Wiring Configuration for the Encoder
8.13 Wiring Configuration for Torque and Stop Limit
9 Maintenance, Diagnostics, and Troubleshooting
9.1 Maintenance and Service
9.2 Heat Sink Access Panel
9.3 Status Messages
9.4 Warning and Alarm Types
9.5 List of Warnings and Alarms
9.6 Troubleshooting
10 Specifications
10.1 Electrical Data
10.2 Mains Supply
10.3 Motor Output and Torque Data
10.4 Ambient Conditions
10.5 Cable Specifications
10.6 Control Input/Output and Control Data
10.7 Fuses and Circuit Breakers
2
VLT® AutomationDrive FC 302
Danfoss A/S © 09/2018 All rights reserved.
63
67
68
68
68
70
70
71
72
72
72
73
73
75
75
75
76
76
77
77
78
79
80
80
80
81
83
84
94
96
96
102
102
102
103
103
106
MG34U502