Enable Telnet - D-Link DGS-3212SR Command Line Interface Reference Manual

DGS-3212SR Switch CLI Reference

enable telnet

Purpose Used to enable communication with and
management of the switch using the Telnet
protocol.
Syntax enable telnet <tcp_port_number>
Description This command is used to enable the Telnet
protocol on the switch. The user can specify the
TCP or UDP port number the switch will use to
listen for Telnet requests.
<tcp_port_number> − The TCP port number.
Parameters
TCP ports are numbered between 1 and 65535.
The "well-known" TCP port for the Telnet
protocol is 23.
Restrictions Only administrator-level users can issue this
command.
Basic Switch Commands
Example Usage:
To enable Telnet and configure port number:
DGS-3212SR:4#enable telnet 23
Command: enable telnet 23
Success.
DGS-3212SR:4#
21