D-Link DGS-3212SR Command Line Interface Reference Manual page 182

DGS-3212SR Switch CLI Reference
config link_aggregation
Used to configure a previously created link
Purpose
aggregation group.
config link_aggregation group_id <value>
Syntax
{master_port <port>|ports <portlist>| {state
[enable|disable]}
This command allows you to configure a link
Description
aggregation group that was created with the
create link_aggregation command above.
<value> − Specifies the group id. The switch
Parameters
allows up to 6 link aggregation groups to be
configured. The group number identifies each of
the groups.
<port> − Master port ID. Specifies which port (by
port number) of the link aggregation group will be
the master port. All of the ports in a link
aggregation group will share the port
configuration with the master port.
<portlist> − specifies a range of ports to be
configured. Ports are specified by entering the
lowest port number in a group, and then the
highest port number in a group, separated by a
dash. So, a port group including the switch ports
1, 2, and 3 would be entered as 1-3. Ports that
are not contained within a group are specified by
entering their port number, separated by a
comma. So, the port group 1-3 and port 26
would be entered as 1-3, 26. Additional ports
can be individually entered by their port number,
separated by commas.
state [enable|disable] − Allows you to enable or
disable the specified link aggregation group.
Only administrator-level users can issue this
Restrictions
command.
Link Aggregation Commands 176