D-Link DGS-3212SR Command Line Interface Reference Manual page 96

DGS-3212SR Switch CLI Reference
config mac_notification
Purpose Used to configure MAC address notification.
Syntax config mac_notification
ports <portlist>|all
interval <sec>
historysize <1 - 500>
Description MAC address notificiation is used to monitor
MAC addresses learned and entered into the
FDB.
Parameters ports <portlist> - specifies a range of ports to
be configured. The port list is specified by
listing the lowest switch number and the
beginning port number on that switch, separated
by a colon. Then highest switch number, and
the highest port number of the range (also
separeted by a colon) are specified. The
beginning and end of the port list range are
seperated by a dash. For example, 1:3 would
specify switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of
the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
all – to configure all ports for MAC notification.
interval <sec 1-2147483647> - time in seconds
between notifications.
historysize <1 - 500> - maximum number of
entries listed in the history log used for
notification.
Restrictions Only administrator-level users can issue this
command.
MAC Notification
Example Usage:
To configure a 60 second interval for MAC address notification on unit 1
ports 6-9:
DGS-3212SR:4#config mac_notification ports 1:6-1:9 60
Command: config mac_notification ports 1:6-1:9 interval 60
Success.
DGS-3212SR:4#
90