D-Link DGS-3212SR Command Line Interface Reference Manual page 143

DGS-3212SR Switch CLI Reference
config 802.1x reauth ports
Purpose Used to configure the 802.1x re-authentication
feature of the switch.
Syntax config 802.1x reauth ports [<portlist>|all]
Description The config 802.1x reauth ports command is
used to enable the 802.1x re-authentication
feature on the switch.
<portlist> − Specifies a range of ports. The port
Parameters
list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example,
1:3 would specify switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port
3 and switch 2, port 4 − in numerical order.
all − Specifies all of the ports on the switch.
Restrictions Only administrator-level users can issue this
command.
802.1X COMMANDS
Example Usage:
To configure 802.1x reauthentication for posrts 1:1-1:15:
DGS-3212SR:4#config 802.1x init ports 1:1-1:15
Command: config 802.1x init ports 1:1-1:15
Success.
DGS-3212SR:4#
137