D-Link DGS-3212SR Command Line Interface Reference Manual page 173

DGS-3212SR Switch CLI Reference
config gvrp
Purpose Used to configure GVRP on the switch.
Syntax config gvrp [<portlist>|all] {state
[enable|disable]|ingress_checking
[enable|disable]}|acceptable_frame
{[tagged_only|admit_all]|pvid <vlanid>}
Description This command is used to configure the Group
VLAN Registration Protocol on the switch. You
can configure ingress checking, the sending and
receiving of GVRP information, and the Port
VLAN ID (PVID).
<portlist> − A range of ports for which you want
Parameters
ingress checking. The port list is specified by
listing the lowest switch number and the
beginning port number on that switch, separated
by a colon. Then highest switch number, and
the highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 1:3 would
specify switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of
the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
all − Specifies all of the ports on the switch.
state [enable|disable] − Enabled or disables
GVRP for the ports specified in the port list.
ingress_checking [enable|disable] − Enables or
disables ingress checking for the specified port
list.
acceptable_frame − determines the type of
frame that will be accepted by the port.
tagged_only − only packets with a VLAN tag
VLAN Commands
will be accepted.
admit_all − all packets will be accepted.
pvid − Specifies the VLAN that will be
associated with the port.
Restrictions Only administrator-level users can issue this
command.
Example Usage:
To set the ingress checking status, the sending and receiving GVRP
information and Port VLAN ID(PVID):
DGS-3212SR:4#config gvrp 1:1-1:5 state enable ingress_checking
enable pvid 21
Command: config gvrp 1:1-1:5 state enable ingress_checking
enable pvid 21
Success.
DGS-3212SR:4#
167