Show Ports - D-Link DGS-3212SR Command Line Interface Reference Manual

DGS-3212SR Switch CLI Reference

show ports

Purpose Used to display the current configuration of a
range of ports.
Syntax show ports {<portlist>}
Description This command is used to display the current
configuration of a range of ports.
<portlist> − Specifies a range of ports to be
Parameters
configured. The port list is specified by listing
the beginning port number and the highest port
number of the range. The beginning and end of
the port list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies port
4. 3-4 specifies all of the ports between port 3
and port 4 − in numerical order.
Restrictions None.
Switch Port Commands
Example Usage:
To display the configuration of the ports:
DGS-3212SR:4#show ports
Command: show ports
Port Port Settings
State Speed|Duplex|FlowCtrl
---- -------- --------------------- ---------------------
1 Enabled Auto|Disabled
2 Enabled Auto|Disabled
3 Enabled Auto|Disabled
4 Enabled Auto|Disabled
5 Enabled Auto|Disabled
6 Enabled Auto|Disabled
7 Enabled Auto|Disabled
8 Enabled Auto|Disabled
9 Enabled Auto|Disabled
10 Enabled Auto|Disabled
11 Enabled Auto|Disabled
12 Enabled Auto|Disabled
13 Enabled Auto|Disabled
14 Enabled Auto|Disabled
15 Enabled Auto|Disabled
16 Enabled Auto|Disabled
17 Enabled Auto|Disabled
18 Enabled Auto|Disabled
19 Enabled Auto|Disabled
20 Enabled Auto|Disabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r
Refresh
Connection Address
Learning
--------
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
100M|Full|None Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
Link Down Enabled
33