D-Link DGS-3212SR Command Line Interface Reference Manual page 194

DGS-3212SR Switch CLI Reference
config igmp_snooping
Purpose Used to configure IGMP snooping on the switch.
Syntax config igmp_snooping [<vlan_name 32>|all]
{host_timeout <sec 1-16711450>|router_timeout
< sec 1-16711450>|leave_timer < sec
1-16711450>|state [enable|disable]}
Description This command allows you to configure IGMP
snooping on the switch|
<vlan_name 32> − The name of the VLAN for
Parameters
which IGMP snooping is to be configured.
host_timeout < sec 1-16711450> − Specifies the
maximum amount of time a host can be a
member of a multicast group without the switch
receiving a host membership report. The default
is 260 seconds.
route_timeout <sec 1-16711450> − Specifies the
maximum amount of time a route will remain in
the switch's can be a member of a multicast
group without the switch receiving a host
membership report. The default is 260 seconds.
leave_timer < sec 1-16711450> − Leave timer.
The default is 2 seconds.
state [enable|disable] − Allows you to enable or
disable IGMP snooping for the specified VLAN.
Restrictions Only administrator-level users can issue this
command.
IGMP Snooping Commands
Example Usage:
To configure the igmp snooping:
DGS-3212SR:4#config igmp_snooping default host_timeout 250
state enable
Command: config igmp_snooping default host_timeout 250 state
enable
Success.
DGS-3212SR:4#
188