Internet Access Configuration - D-Link DI-106 Series User Manual

Address Allocation for Private Internets and RFC 1466,
Guidelines for Management of IP Address Space .
Once you have determined the IP address range for your local
network, you may want to use DHCP (Dynamic Host
Configuration Protocol) to assign addresses to individual hosts on
the network, as an alternative to manually configuring each host's
IP settings. See the TCP/IP and DHCP section on page 43 for more
information about DHCP.

Internet Access Configuration

This section describes how to configure your DI-106 or DI-106M
for Internet access. The information you will need to provide will
be indicated in bold type.
Note that configuring the router for Internet access will
automatically create a new entry in the Remote Node Setup menu
(menu 11). Before carrying out the following steps, check the
Remote Node Setup menu to make sure there is space for a new
entry. In order for you to be able to configure the router for
Internet access, there must be no more than three entries in the
Remote Node Setup menu before you start.
Configuring for Internet Access 49