D-Link DI-106 Series User Manual page 142

The User needs to configure the following 3 parameters to activate
syslog:
1. Active—Use the space bar to turn the syslog option on or off.
2. Syslog IP Address—Input the IP Address that you wish to send
your syslog to. The address is usually written in dotted decimal
notation such as a.b.c.d where a, b, c, and d are numbers
between 0 and 255.
3. Log Facility—Use the space bar to toggle between the 7
different Local options. This feature is used for UNIX
applications.
Your DI-106 or DI-106M will send three different types of syslog
messages: Call information messages (i.e. CDR), Error information
messages, and Session information messages. Some examples of
these messages are shown below:
Call Information Messages:
134 System Maintenance