Table of Contents
Advertisement
Remote Node Setup
Follow the instructions in the chapter entitled Remote Node
Configuration, starting on page 57, to fill in the protocol-
independent parameters in menu 11, Remote Node Profile. For the
protocol-dependent parameters, follow the instructions below. If
the DI-106M is configured to receive incoming calls, you can
configure the default dial-in parameters in menu 13 (see the chapter
entitled Dial-In Configuration, starting on page 68).
1. Route—Make sure IPX is among the protocols in the Route
field.
2. Edit IP/IPX/Bridge—Press the space bar to change the setting
to Yes, then press Enter to go to the Remote Node Network
Layer Options menu.
1. Dial-On-Query—This field is necessary for the DI-106M on
the client side LAN. When set to Yes, any "Get Service" SAP or
RIP broadcasts coming from the LAN will trigger the DI-106M
92
Novell IPX Configuration
Advertisement
Table of Contents
