Can't Access The Internet; Can't Access Remote Management - D-Link DSL-2700U User Manual

I cannot get a WAN IP address from the ISP.
STEPS
1 The ISP provides the WAN IP address after authenticating you. Authentication may be
through the username and password, the MAC address or the host name.
2 The username and password apply to PPPoE and PPPoA encapsulation only. Make
sure that you have entered the correct Service Type, User Name and Password (be
sure to use the correct casing).

Can't Access the Internet

I cannot access the Internet.
STEPS
1 Make sure the router is turned on and connected to the network.
2 If the DSL LED is off, refer to Section A.1.3.
3 Verify your WAN settings.
4 Make sure you entered the correct username and password.
5 For wireless stations, check that both the router and wireless station(s) are using
the same ESSID, channel and WEP keys (if WEP encryption is activated).
Internet connection disconnects.
STEPS
1 Check the schedule rules.
2 If you use PPPoA or PPPoE encapsulation, check the idle time-out setting.
3 Contact your ISP.

Can't Access Remote Management

I cannot remotely manage the ROUTER from the LAN or WAN.
STEPS
Refer to the Remote Management Limitations section in the Firmware and Configuration
1
File Management chapter for scenarios when remote management may not be possible.
2 Use the router's WAN IP address when configuring from the WAN.
Use the router's LAN IP address when configuring from the LAN.
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
62