Generic Filter Rule - D-Link DI-106 Series User Manual

Generic Filter Rule

This section will show you how to configure the protocol-
independent parameters for a Generic filter rule for your DI-106 or
DI-106M. For information on the protocol-dependent fields, refer
to the previous section, TCP/IP Filter Rule, and the following
section, Novell IPX Filter Rule. The fields in the menu are indicated
in bold type.
1. Offset—Offset refers to the value of the byte that you want to
use as your starting offset. That is, in the data packet, at what
point do you want to begin the comparison. The range for this
field is from 0 to 255. Default = 0
2. Length—This field refers to the length (in bytes) of the data in
the packet that the router should use for comparison and
masking. The starting point of this data is determined by Offset.
The range for this field is 0 to 8. Default = 0
112 Filter Configuration