D-Link DI-106 Series User Manual page 70

amounts of traffic. Press the space bar to select either Yes or
No.
14. Edit PPP Options—To edit the PPP options for this Remote
Node, move the cursor to this field, use the space bar to select
Yes and press ENTER. This will bring you to menu 11.2,
Remote Node PPP Options. For more information on
configuring PPP options, see the section entitled "Editing PPP
Options."
15. IP Addr—This is a required field if Route is set to IP. Enter
the IP address of this Remote Node.
16. Edit IP/IPX/Bridge Options—To edit the parameters of the
protocols, go to this field, select Yes and press ENTER. This
will bring you to menu 11.3, Remote Node Network Layer
Options. For more information on filling out this screen, refer
to the chapter pertaining to your specific protocol.
17. Telco Options: Transfer Rate—This field (which only applies
to outgoing calls) controls the rate at which the data is
transferred between your router and the Remote Node. The
options for this field are:
64K—The router will place 64-kbps (kilobits per second)
digital data calls.
56K—(For North America only) The router will place 56-
kbps digital data calls.
Lease line—The router will place leased-line calls.
DOVBS—This option is for North America only. The
router will place 56-kbps Data Over Voice Bearer Service
(DOVBS) calls. Some phone companies in North America
charge less if calls are made with the DOVBS option.
62 Remote Node Configuration