Table of Contents
Advertisement
example, 5551212). Note that these fields will only accept
digits, so hyphens and spaces will not be accepted.
Analog Call—The router can direct an incoming analog call
to standard phone jack 1 or to standard phone jack 2, or treat
it as a data call, on the basis of the number being called. On
the worksheet, check the way analog calls to each phone
number are to be handled.
The Phone1 setting directs incoming analog calls for the
associated number to standard phone jack 1 (also referred to as
A/B adapter 1, POTS [Plain Old Telephone System] port 1, and
analog port 1). The Phone2 setting directs such calls to standard
phone jack 2.
The DOVBS setting is used for Data Over Voice Bearer
Service, also known as Data Over Speech Bearer Service, or
DOSBS. This is a service available from some ISDN providers
that declares incoming ISDN data calls as analog. Check this
setting if your service contract specifies DOVBS on the
associated number.
SPID Number(s)—(For North America only) The SPID
(Service Profile Identifier) is a number used by a central
office switch for identification purposes. With the switch
information, see the previous table for the number of SPIDs
you must enter.
You have now collected all of the necessary information about your
ISDN phone line. Make sure that these values are entered into your
worksheet before you continue to the next section. For DSS1 and
1TR6 ISDN, refer to the Installation chapter starting on page 23.
16
Before You Begin
Advertisement
Table of Contents
