Viewport Error Log Message Formats - Crestron CHV-THSTAT Operation And Installation Manual

Crestron CHV-TSTAT and CHV-THSTAT
Operations and Installation Guide – DOC. 8163C

Viewport Error Log Message Formats

When a remote sensor that has been designated as USE, SLAB, or OD in the Setup
Sensors screen generates an error, a message is sent to the error log. Retrieve this
message using Viewport, Function | 2-Series | Error Log | Show Error Log.
Error Message Format
Sensor <channel> type <designator> <CHA errors>, <CHB
errors> Errors @ <cycle count>
Where:
channel is the sensor channel string
designator is the sensor setup designation
CHA errors/CHB errors are the number of errors on each sub-channel
cycle count is the number of read cycles that have occurred.
NOTE: Both sub-channels have their error count reported, regardless of the sensors
connected.
This message is sent upon the first error on the channel, as well as every 100 errors
thereafter. The following is an example output, as seen in Viewport, when a single
OD sensor on channel one fails.
Error: Message from device Slot-09.ID-2A: Sensor R1T
type OD: 2,3 Errors @ 3922 (0056:0000:0056)
Thermostats: CHV-TSTAT and CHV-THSTAT • 83
Thermostats