Crestron CHV-THSTAT Operation And Installation Manual page 64

Thermostats
Humidity Screen
Humidity
MODE
30
% 24 %
VIEW
Outdoor Screen
Outdoor
MODE
32
o F
VIEW
Messages Screen
Messages
MODE
<CLR
Emergency Gen in Use
VIEW
58 • Thermostats: CHV-TSTAT and CHV-THSTAT
Crestron CHV-TSTAT and CHV-THSTAT
VIEW Button
VIEW
The following screens are accessed by pressing the VIEW button:
1. Humidity (If enabled in Setup)
2. Outdoor (If enabled in Setup)
3. Messages
NOTE: If enabled, the VIEW button also allows access to the remote button
function screens. When part of a Cresnet system, the up ▲ and down ▼
arrow buttons can be used to enable other functions (i.e., lighting control,
alarm system, etc.).
1. Humidity
Press the VIEW button to display the "Humidity" screen. The setpoint
adjustment range is 5 – 70%.
Use the up ▲and down ▼arrow buttons to adjust the Humidity Set Point
level. This page only appears if enabled in the "HUM OPTS" setup screen
and the thermostat is equipped with a humidity sensor.
NOTE: If a CHV-RTHS temperature/humidity sensor is installed, a CHV-
TSTAT can import and display the humidity.
2. Outdoor
Press the VIEW button again to display the "Outdoor" screen. This allows
the user to view the outdoor temperature (if an outdoor sensor has been
installed) and outdoor humidity (if available). Outdoor temperature/humidity
can come from an outdoor sensor wired directly to the thermostat or through
the Cresnet system from another source. This page is only displayed if
enabled in the "SCRN OPTIONS" setup screen.
NOTE: This is only a display and not for system activation. This display can
be shown on either the CHV-TSTAT or the CHV-THSTAT.
3. Messages
Press the VIEW button again to display the "Messages" screen. This screen
allows the user to view any text messages sent from the control system (only
when part of a Cresnet system). Text messages are limited to four lines,
approximately 20 characters per line (including spaces). Allow for word
wrap by staying within the 20 characters/spaces per line maximum. The
thermostat auto-hyphenates when nearing the end of a line. You may use
carriage returns to force a line change.
NOTE: This page is only seen when a message has been sent to the
thermostat.
Press the MODE button to clear (CLR) the message(s). Acknowledges to the
control system that the message has been read.
Operations and Installation Guide – DOC. 8163C