Related Manuals for Crestron CHV-TSTAT-FCU
Summary of Contents for Crestron CHV-TSTAT-FCU
- Page 1 CHV-TSTAT-FCU Heating and Cooling Fan-Coil Thermostat Supplemental Guide Crestron Electronics, Inc.
- Page 2 Certain Crestron products contain open source software. For specific information, please visit www.crestron.com/opensource. Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
-
Page 3: Table Of Contents
Contents Introduction Set Up the Thermostat Enter Setup Mode Navigate Setup Mode Configure the Thermostat Supplemental Guide — Doc. 7963B Contents • i... - Page 4 ii • Contents Supplemental Guide — Doc. 7963B...
-
Page 5: Introduction
Introduction After installation, set up the Crestron® CHV-TSTAT-FCU. Refer to the information that follows for an overview of the setup procedure. For more installation information on the CHV-TSTAT-FCU, refer to the CHV-TSTAT-FCU DO Guide (Doc. 7914) at crestron.com/manuals. Supplemental Guide — Doc. 7963B... -
Page 6: Set Up The Thermostat
When the device is in Setup mode, press the MODE button to advance to the next screen, press the VIEW button to scroll vertically through the setup options on the screen, and press the Up (p) and Down (q) buttons to change the value for the selected item. 2 • CHV-TSTAT-FCU Supplemental Guide — Doc. 7963B... -
Page 7: Configure The Thermostat
NOTE: A two-stage system can be used only if the O and B terminals are not currently wired for a different application. Supplemental Guide — Doc. 7963B CHV-TSTAT-FCU • 3... - Page 8 Use Call FAN in HUM to activate or disable the fan during calls to the humidifier. 4 • CHV-TSTAT-FCU Supplemental Guide — Doc. 7963B...
- Page 9 Setting Dis Rem Func Pg1 and Pg 2 to Y enables viewing of the sensor state when the VIEW button is pressed. Setting Reverse SMODE Dir to Y reverses the direction that the System Mode selection scrolls across the screen when the Up (p) or Down (q) arrows are pressed. Supplemental Guide — Doc. 7963B CHV-TSTAT-FCU • 5...
- Page 10 Disable Auto Mode removes the auto option from the System Mode screen. SETUP: SENSORS Screen The SETUP: SENSORS screen allows defining which sensors are used to report temperature and humidity to the thermostat. 6 • CHV-TSTAT-FCU Supplemental Guide — Doc. 7963B...
- Page 11 The SETUP: SERVICE/TEST screen allows testing of the HVAC system directly from Setup mode. Set the Heat Call, Cool Call, Humidifier Call, or Fan Call to ON to test the HVAC system. Supplemental Guide — Doc. 7963B CHV-TSTAT-FCU • 7...
- Page 12 This page is intentionally left blank. Supplemental Guide — Doc. 7963B CHV-TSTAT-FCU • 8...
- Page 13 Supplemental Guide — Doc. 7963B Crestron Electronics, Inc. (2048037) 15 Volvo Drive, Rockleigh, NJ 07647 11/03/22 Tel: 888.CRESTRON Specifications subject to Fax: 201.767.7656 change without notice. www.crestron.com...