Crestron CHV-THSTAT Operation And Installation Manual page 42

Thermostats
OTHER SETTINGS
SETUP:
OTHER SETTINGS
NO APPLICABLE SETTINGS
SERVICE/TEST
SETUP: SERVICE/TEST
Slab Heat Call:
Humidifier Call:
Fan Call:
NOTE: This screen bypasses all system delays
and is used by the installer to manually operate
the HVAC system. Only one system can be run
at a time.
Press MODE button to return to the first screen.
Simultaneously press and hold the MODE and
VIEW buttons to return to normal operation
mode.
36 • Thermostats: CHV-TSTAT and CHV-THSTAT
Crestron CHV-TSTAT and CHV-THSTAT
Slab 1 – Floor Warming Only (Continued)
NOTE: Built-in temperature sensor signal locked out
in Floor Warming mode for Slab 1 system type.
Choose SLAB (Remote Sensors Only)
NOTE: Remote 1 and Remote 2 options do not
appear on this screen if these sensors are not
connected.
OFF
OFF
OFF
NOTE: You cannot exit if the sensor setup does not meet
system requirements.
SENSORS
SETUP: SENSORS
Sensor
Internal:
Remote 1:
DETECTED: 1 x T
Remote 2:
Press MODE button to return to the first screen
Or
Press and hold the MODE and VIEW buttons
simultaneously for five seconds to exit Setup.
Operations and Installation Guide – DOC. 8163C
>TEMP HUM
OMIT USE
SLAB