Table of Contents
Advertisement
Å
ı
BRAKE HOSE INSPECTION/
DRIVE CHAIN SLACK ADJUSTMENT
3 - 34
NB1A3012
BRAKE HOSE INSPECTION
WARNING
Securely support the motorcycle so there is
no danger of it falling over.
1.Place the motorcycle on a level place.
2.Inspect:
Brake hose(s) 1
Cracks/wear/damage → Replace.
Å Front
ı Rear
3.Hold the motorcycle on upright position
and apply the front brake and/or rear brake.
4.Check:
Fluid leakage
Active the brake lever and/or brake pedal
several times.
Fluid leakage → Replace.
Refer to "FRONT AND REAR BRAKE" in
CHAPTER 6.
NB1A4007
DRIVE CHAIN SLACK ADJUSTMENT
NOTE:
Before checking and/or adjusting, rotate the
rear wheel several revolutions and check
slack at several points to find the tightest
point. Check and/or adjust the chain slack
with the rear wheel in its "tightest" posi-
tion.
CAUTION:
Too little chain slack will overload the
engine and other vital parts. Keep the slack
within the specified limits.
WARNING
Securely support the motorcycle so there is
no danger of it falling over.
1.Place the motorcycle on its centerstand.
NOTE:
Elevate the rear wheel by placing a suitable
stand under the engine if a centerstand is
not equipped.
CHK
ADJ
Advertisement
Table of Contents
