Table of Contents
Advertisement
Make sure the projection on the front fork is placed in the slot in the speedometer gear unit.
Ò Pass the wireharness over the fuel tank bracket.
˜ Pass the wireharness under the regulator lead coupler. Make sure the coupler does not go over the
right side.
ˆ Insert the coupler on the inside of the ground lead.
Ø Pass the clamp through the right engine stay.
∏ Face the band end to the inside of the vehicle.
ΠPass the ignition coil lead on the inside of the throttle cable.
 Align the slot and the projection on the front fork.
CABLE ROUTING
2 - 26
SPEC
Advertisement
Table of Contents
