Table of Contents
Advertisement
STEERING HEAD AND HANDLEBAR
6 - 55
3.Tighten:
Ring nut 1
*********************************
Tightening steps:
Tighten the ring nut using the ring nut
wrench 2.
Ring nut wrench:
P/N. YU-33975
NOTE:
Set the torque wrench to the ring nut
wrench so that they form a right angle.
Ring nut 1 (lower) (initial tightening):
5 Nm (0.5 m • kg, 3.6 ft • lb)
Turn the lower bracket to the left and right
making sure there is no binding, and then
loosen the ring nut one turn.
Retighten the ring nut using the ring nut
wrench.
Ring nut 1 (lower) (final tightening):
38 Nm (3.8 m • kg, 27 ft • lb)
WARNING
Avoid over tightening.
NOTE:
Check the steering head by turning the
steering from lock to lock, after adjusting
the steering head. If the steering is stiff,
loosen the ring nut but not to the extent of
allowing free play in the bearing. If the
steering is loose, repeat the adjustment
steps.
*********************************
4.Install:
Rubber washer
Ring nut 1
Lock washer 2
CHAS
Advertisement
Table of Contents
