Icom IC-M510 Instruction Manual page 97

• Radio
[MENU] > Settings > Radio
Scan Type
(Except for the NLD version)
Selects the scan type. The default setting
differs, depending on the transceiver
version.
L See page 16 for details.
Normal Scan: Scans all Favorite channels in
the selected channel group.
Priority Scan: Sequentially scans all
Favorite channels, while
periodically checking
Channel 16.
Scan Timer
(Except for the NLD version)
You can use the Scan Timer to pause, or to
resume after 5 seconds, when a signal is
detected.
ON: When a signal is detected on a
channel, the scan pauses for 5
seconds, and then resumes. If
the signal disappears in less than
5 seconds, the scan immediately
resumes.
OFF: When a signal is detected on a
channel, the scan pauses until
the signal disappears, and then
resumes.
Dual/Tri-watch
(Except for the NLD version)
Select Dualwatch or Tri-watch.
L See page 18 for details.
Dualwatch: Periodically checks Channel
16 while operating on
another channel.
Tri-watch: Periodically checks Channel
16 and the Call channel
while operating on another
channel.
Channel Group
Select the suitable channel group for your
operating area. Select USA, INT, or CAN,
depending on the transceiver version.
L See page 10 for details.
MENU SCREEN
Call Channel
You can change your Call channel. The
default setting may differ, depending on the
transceiver version.
L See page 13 for details.
WX Alert
For the USA version, an NOAA broadcast
station transmits a Weather Alert tone
before any important weather information.
L See page 11 for details.
ON with Scan:
The preset Weather channels
are sequentially checked while
scanning.
ON: The previously selected (last used)
Weather channel is checked while
scanning.
OFF: The Weather Alert tone is not
detected.
Voice Scrambler
L Displayed only when a Voice scrambler
unit is installed.
z Function
Turn the Voice Scrambler function ON
or OFF.
z Codes
Set the Voice Scrambler code
to between 1 and 32. In order to
understand each other, all transceivers
in your group must use the same
scramble code, as well as the same
scrambler unit.
Favorite CH
You can set all channels as Favorite
channels, clear all settings, or reset to
default. By default, some channels are
preset. The Favorite channels differ,
depending on the transceiver version.
L See page 17 for details.
Set All Channels: Sets all channels as
Favorite channels.
Clear All Channels: Clears all Favorite
channels.
Set Default: Resets Favorite
channels to the default.
10
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
84