Icom IC-M510 Instruction Manual page 53

D Receiving a Position Request call
(May not be used, depending on the presetting)
NOTE: Even if the Auto ACK function is set to "Manual," after receiving a Distress
Acknowledgment, or while in the Distress Cancel call procedure, the Position Reply is
automatically sent to the calling station.
When a Position Request call is received:
• An alarm sounds.
• "Received POS Request" is displayed.
1. Push Alarm OFF to turn OFF the alarm.
2. Push the Software Key below the intended operation.
Ignores the call and returns to the
Ignore
:
operating screen.
• The call is saved in the DSC Log.
• "
the call message.
Holds the RX call task, and returns to the
Hold :
Main screen.
Sends Acknowledgment "Able to comply"
Able :
right away.
( Able to
comply)
Sends an Acknowledgment "Unable to
Unable :
Comply."
(Unable to
• The call is saved in the DSC Log.
Comply)
• Displays the Acknowledgment
information, and then returns to the
operating screen by pushing
then
Accepts the call.
Accept
:
• Displays the received call's information.
• The call is saved in the DSC Log.
Push
Call
(p. 32)
DIGITAL SELECTIVE CALLING (DSC)
" blinks continuously until you display
OK .
ACK Able or ACK Unable
to send the Position Reply call.
STBY
, and
, then push
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
40