Icom IC-M510 Instruction Manual page 45

D Sending a Position Reply call
Send a Position Reply call when a Position Request call is received.
If the Auto ACK function is set to "Auto," the Acknowledgment is automatically sent to the
calling station. (p. 46)
1. After a Position Request is being received, push
Alarm OFF to turn OFF the alarm.
• The received call's information is displayed.
2. Push the Software Key below the intended operation.
Ignores the call and returns to the
Ignore
:
operating screen.
• The call is saved in the DSC Log.
• "
the call message.
Holds the RX call task, and returns to the
Hold
:
Main screen.
Sends Acknowledgment "Able to comply"
Able
:
right away.
( Able to
• The call is saved in the DSC Log.
comply)
• Displays the Acknowledgment
information, and then returns to the
operating screen by pushing
then
Sends an Acknowledgment "Unable to
Unable :
Comply."
(Unable to
• The call is saved in the DSC Log.
Comply)
• Displays the Acknowledgment
information, and then returns to the
operating screen by pushing
then
DIGITAL SELECTIVE CALLING (DSC)
" blinks continuously until you display
OK .
OK .
STBY
, and
STBY
, and
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
32