2: Digital Setpoint Value, 2 Operating Directions - Eaton Cutler Hammer PowerXL DC1 E1 Series Parameter Manual

3 Control signal terminals
3.2 Configuration of the control signal terminals
3.2.3 P-12 = 2: digital setpoint value, 2 operating directions
P-15 DI1
(terminal 2)
0 START
1 Not permissible
2 FWD
3 FWD
4 START
5 Not permissible
6 START
7 FWD
8 Not permissible
9 Not permissible
10 Not permissible
11 Not permissible
12 Not permissible
13 FWD
14 Not permissible
15 FWD
16 FWD
17 FWD
18
Table 11: P-12 = 2: digital setpoint value, 2 operating directions
DI2
(terminal 3)
UP
UP
UP
UP
DIR
REV
No function
Select f-Fix/DIG REF
Select f-Fix4/DIG REF
Select DIG REF/f-Fix4
The setpoint value is set using the keypad = digital setpoint value. The arrow
buttons are used to adjust the setpoint value.
P-12 = 2: If the motor is running, pressing the green button again will reverse
the operating direction. The last operating direction will be stored when the
unit is switched off.
DC1...E1 Variable Frequency Drives 11/16 MN040022EN www.eaton.com
DI3/AI2
(terminal 4)
DOWN
DOWN
EXTFLT
Select DIG REF/AI1 REF
EXTFLT
EXTFLT
EXTFLT
Select Fire Mode/Normal OP
Select Fire Mode/Normal OP
Select Fire Mode/Normal OP
DI4/AI1
(terminal 6)
DIR
Select DIG REF/f-Fix1
DOWN
AI1 REF
Select DIG REF/f-Fix1
Select DIG REF/f-Fix1
No function
Select f-Fix4/f-Fix2
DIR
DIR