Control Via Keypad - Eaton Cutler Hammer PowerXL DC1 E1 Series Parameter Manual

2.6 Control via keypad

Table 7: Control via keypad
Button Attribute ID
OK
START
START
OK
STOP
Hint:
In this mode, a high-level signal must be applied at terminal 2 (DI1) as an enable signal for the DC1 variable
frequency drive.
DC1...E1 Variable Frequency Drives 11/16 MN040022EN www.eaton.com
Explanation
P-12 = 1 or = 2
• P-12 = 1: one operating direction (FWD)
• P-12 = 2: two operating directions (FWD/REV)
Starts the variable frequency drive
▲ Increase speed
▼ Decrease speed
Changes the operating direction if the motor is running
Hint:
Only if P-12 = 2
Changes the value being displayed: A, rpm, etc.
Stops the variable frequency drive
2 HMI device
2.6 Control via keypad
11