9: Swd Control + Setpoint Value - Eaton Cutler Hammer PowerXL DC1 E1 Series Parameter Manual

3.2.10 P-12 = 9: SWD control + setpoint value
P-15 DI1
(terminal 2)
0 ENA
1 Not permissible
2 Not permissible
3 Not permissible
4 Not permissible
5 Not permissible
6 Not permissible
7 Not permissible
8 Not permissible
9 Not permissible
10 Not permissible
11 Not permissible
12 Not permissible
13 ENA
14 Not permissible
1)
15 ENA
2)
16 ENA
17 ENA
1) If P-15 = 15 and fire mode is active, the drive will run with fixed frequency 4 (f-Fix4), which is set with P-13.
2) If P-15 = 16, the setpoint value selection will be independent from fire mode.
Table 18: P-12 = 9: SWD control + setpoint value
DI2
(terminal 3)
No function
No function
No function
Select AI1/f-Fix2
Select f-Fix Bit0
DC1...E1 Variable Frequency Drives 11/16 MN040022EN www.eaton.com
3.2 Configuration of the control signal terminals
DI3/AI2
(terminal 4)
No function
EXTFLT
Select Fire Mode/Normal OP
Select Fire Mode/Normal OP
Select Fire Mode/Normal OP
3 Control signal terminals
DI4/AI1
(terminal 6)
No function
No function
No function
AI1 REF
Select f-Fix Bit1
25