Terminal Block X1B Motor Connection; Wiring Of The Motor; Figure 13: Terminal Block X1B Motor Connection; Figure 14: Wiring Of The Motor - KEB COMBIVERT G6 Instructions For Use Manual

CONNeCTION Of THe POWer UNIT

4.2.5.7 Terminal block X1B motor connection

X1b
Figure 13: Terminal block X1B motor connection

4.2.5.8 Wiring of the motor

Legend
1 KEB COMBIVERT
2
3 Three-phase motor
4
5 Connection via shield plate (if not available, place on mounting plate)
Figure 14:
NOTICE
40
Name function
Motor connec-
U, V, W
tion
Connection for
PE,
protective earth
T1 T2
L1
L2
L3
Apply motor cable, shielding on both sides over a large surface on the motor
housing
Temperature monitoring (optional)
=>
„4.2.7 Connection of a temperature detection"
Wiring of the motor
ensure correct laying of the PTC cables !
• Do not lay PTC cable of the motor (also shielded) together with con-
trol cable !
• PTC cable inside the motor cable only permissible with an addition-
ally shielding (double shielding) !
Cross-section
AWG without mm² with
wire-end wire-end
ferrule ferrule
20...8 2.5...10
stranded wire
Screw M4
for ring crimp connector
U
U
V V
W W
➄
Tightening
torque
1.2...1.5 Nm
12 lb-inch
1.3 Nm
11 lb inch
➃