Product Features - KEB COMBIVERT G6 Instructions For Use Manual

PrODUCT DeSCrIPTION

2.3 Product features

This instruction manual describes the power circuits of the following devices:
Device type:
Series:
Power range:
Housing:
The COMBIVERT G6 is characterized by the following features:
•
•
•
•
•
•
•
•
•
•
•
•
22
Drive controller
COMBIVERT G6
5.5...11 kW / 400 V
C
Operation of three-phase asynchronous motors and three-phase synchronous
motors, in operating modes open-loop or closed-loop without speed feedback
Following fieldbus systems are supported: EtherCAT, VARAN, IO-Link or CAN-
Open
Comprehensive operating concept
Wide operating temperature range
Low switching losses by IGBT power unit
Low noise development due to high switching frequencies
Different heat sink concepts:
• Air cooler as built-in version
• Flat rear version
Temperature-controlled fan, replaceable
Depending on the operating mode, the torque limits and s-curves are adjustable
(to protect the gearbox)
General protection functions of the COMBIVERT series against overcurrent, over-
voltage, ground fault and overtemperature
Analog inputs and outputs, digital inputs and outputs, brake control and supply,
motor protection by I²t, KTY or PTC input, diagnostic interface, fieldbus interface
(depending on the control board)
Potential-free relay output