Installing The Boss S2 Module - Dell EMC PowerEdge R350 Installation And Service Manual

Figure 55. Removing the BOSS S2 module
Next steps
1. Replace the BOSS S2

Installing the BOSS S2 module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If required, remove the air
Steps
1. Install the BOSS S2 module into the BOSS module cage.
2. Using the Phillips #1 screwdriver, secure the BOSS S2 module on the BOSS module bay with the two screws.
Figure 56. Installing the BOSS S2 module
module.
Safety
Before working inside your
shroud.
instructions.
system.
Installing and removing system components 63