Installing The Boss S2 Module - Dell EMC PowerEdge E75S Series Installation And Service Manual

9. Using the Phillips #1 screwdriver, remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS cover on the BOSS S2
module. Slide the BOSS cover out from the BOSS S2 module.
Figure 79. Removing the BOSS cover
Next steps
1. Replace the BOSS S2

Installing the BOSS S2 module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If required, remove the air
module.
Safety
Before working inside your
shroud.
instructions.
system.
Installing and removing system components 85