Programming Line Chef™ Oven - Cadco CAPO-203 User Manual

• Venturi will be used in some bakery applications, such as croissants, cakes and cookies, when a
dry environment is desired.
Programs in Memory
The Line Chef™ Combination Oven is capable of remembering up to 70 programs in its memory bank.
Having preset programs can take the guesswork out of your food preparation as well as save valuable
time.
Your programs will assure perfectly cooked foods every time as long as your products are:
• a consistent size
• prepped and cooked following the same recipe each time
• cooked from a consistent temperature
• from the same manufacturer
• cooked in [approximately] the same quantity
• cooked in the same sized pan
The more you can standardize your production and prep procedures the more successful, and useful
your preset programs will be.
To set a program into memory
• Before you start programming the oven, turn the "Program" dial to an unused number. Unused
numbers will show "000" in the "Time" window and the "Temperature" window will read "032".
• The program number will appear in the window by the "Number" dial.
• Enter the values in each cycle you wish to use.
• Press and hold the "Prog Mem" touch pad by the number dial until you hear the tone after each
cycle being programmed. The tone indicates that your new program has been accepted into
memory.
• Review the values in the cycles you have chosen by pressing the touch pad and moving the light
to illuminate the various cycles you wish to check.
To set a multi step program [up to 4 cycles];
This example is a multi step program used for oven roasting a whole, 3 pound chicken.
to save this program in the memory bank you will want to find a vacant program before programming
the Line Chef™ Combination Oven.
• Press the "Change Set Mode" touch pad to illuminate the "Set Temp" light next to the "Cavity"
icon.
• Press the touch pad next to the "Time" dial to indicate "Cycle 1".
• Program, for example, a combi cycle of 15 minutes, 20% humidity, and 325ºF. [To save press
"Prog Mem"]
• Press the touch pad next to the "Time" dial to indicate "Cycle 2".
• Program in a convection cycle of 18 minutes, at 400ºF. [To save press "Prog Mem"]
• Press "Manual Start/Stop" to start cooking.
To remove a program from memory
• Dial the number of the program you wish to eliminate into the "Program" window.
• Zero out all values in each cycle of the memorized program.
• Press and hold "Prog Mem" until the tone sounds in each cycle of the program you wish to
remove.
10
If you are going