Table of Contents
Advertisement
4/67
Safety instructions
Trademark right third parties
2.4
Qualification of personnel
2.5
General safety instructions
2.6
Product- and technology-dependent safety instructions
2.6.1
Protection from electric voltage
2.6.2
Protection from mechanical danger
Bosch Rexroth AG R911336703_Edition 03
Observe the trademark rights of third parties during assembly and use of sin‐
gle components delivered from Bosch Rexroth. For any infringement of the
right, the customer is liable for the accruing damage.
This operating instruction is intended for persons, who are familiar with trans‐
portation, installation, assembly, start-up and operation of components of
electric drive and control systems and therewith associated danger and they
must have appropriate qualifications.
All persons, working on, with or near an electric facility, must know the safety
requirements, safety instructions and operating instructions (DIN EN
50110-1).
Do not install or operate motors or components of an electric drive and con‐
trol system, as long as you have not read and understood all relevant docu‐
ments.
Please observe the respectively valid national, local and plant-specific regula‐
tions, the safety notes in the documentation and the warning signs on the
components.
Improper use of the components and non-observance of the described safety
notes can lead to damage, bodily injury, electric shock or in extreme case
lead to death.
In the case of damage due to non-observance of the safety notes, Bosch
Rexroth assumes no liability.
Work required on the electric system may only be carried out by skilled elec‐
tricians. Tools for electricians (VDE tools) are absolutely necessary.
Before working:
1. Enable.
2. Secure against reactivation.
3. Ensure de-energization.
4. Ground and short-circuit.
5. Cover or shield any adjacent live parts.
After completing the job, cancel the measures in reverse order.
Dangerous voltage occurs during operation! Danger to life, risk of injury by
electric shock!
●
Before start-up, connect the protective conductors on all electric compo‐
nents according to the connection plan.
●
Operation, even for short measuring purposes is only allowed with fixed
connected protective conductor on the specified points of the compo‐
nents.
Dangerous movements! Danger to life, risk of injury, heavy injury or material
damage.
MBT Synchronous Torque Motors
Advertisement
Table of Contents
