Platform Control Station - JLG EC600SJ Operation And Safety Manual

Platform Control Station

(See Figure 3-2., Platform Control Station)
1. Speed Mode
Activating the Speed Mode switch allows the operator to
High or Low Speed travel operation.
2WD - On 2WD machines, a two-posi-
tion switch is used. The forward posi-
tion selects High Speed travel and the
lower position selects Low Speed
travel.
4WD - On 4WD machines, a three-posi-
tion switch is used. The forward position
selects High speed mode. The middle
position selects Low Speed mode and
Automatic 4WD. The lower position is
momentary and selects Manual 4WD. It
must be held down as long as Manual
4WD is required.
31215027
SECTION 3 - MACHINE CONTROLS AND INDICATORS
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR SLIGHT LEVELING OF
THE PLATFORM. INCORRECT USE COULD CAUSE THE LOAD/OCCUPANT TO SHIFT OR
FALL. FAILURE TO DO SO COULD RESULT IN DEATH OR SERIOUS INJURY.
2. Platform Leveling Override
A three position switch allows the operator to
adjust the automatic self leveling system. This
switch is used to adjust platform level in situa-
tions such as ascending/descending a grade.
3.
Horn
A push-type Horn switch supplies electrical
power to an audible warning device when pressed.
3-7