Lucent Technologies SLC-2000 Remote Terminal Assembly Manual page 70

363-208-010
Cabling, Wiring, and Assembly
Cinch Connectors
Cinch connectors as furnished on factory equipment (shelves and intershelf cable
assemblies) are the insulation displacement (ID) type. The connectors furnished
for use by installers are also ID type requiring the use of special tools for wire
insertion or replacement.
Each plug/jack connector combination has an associated covering (hood) which
must be installed over the connector to complete the assembly.
Each plug and jack connector has terminal numbers embossed on the pin and
wiring sides of the assembly.
Figure 3-1. Cinch Type Connectors
3-4
Issue 5 May 1997
TO
DISCONNECT
2 PULL
1
PRESS AND
HOLD CLIP