Lucent Technologies SLC-2000 Remote Terminal Assembly Manual page 30

363-208-010
General Information
7. Never touch uninsulated wiring or terminals carrying direct current or ring-
ing current or leave this wiring exposed. Protect and tape those wires and
terminals to avoid risk of fire, electrical shock, and injury to service person-
nel.
8. Use caution when installing or modifying telecommunication lines.
9. This product should be operated only from the type of power source indi-
cated on the marking label. For information on proper electrical distribution
and power requirements, refer to the Application Schematic drawing con-
tained in the APPLICATIONS chapter of this manual.
10. To reduce the risk of electrical shock, do not disassemble this product. Ser-
vice should be performed by trained personnel only. Opening or removing
covers and/or circuit packs may expose you to dangerous voltages or other
risks. Incorrect reassembly can cause electrical shock when the unit is sub-
sequently used.
11. Use only Lucent Technologies manufactured UL
in this system.
* Registered trademark of Underwriters Laboratory, Inc.
1-6
Issue 5 May 1997
*
recognized circuit packs