Lucent Technologies SLC-2000 Remote Terminal Assembly Manual page 279

363-208-010, Appendix 3
Test Head Installation
SLC-2000 Access System Circuit Packs
General
These procedures verify that the software and the circuit packs in the SLC -2000
Access System shelves that are required for the operation of the Lucent
Technologies RTH-7000 or General Signal Networks Tau-tron ngRTH test head
are present. See Table 1-3 for the circuit packs that must be present in the SLC -
2000 Access System for the operation of the test head.
Table 1-3. SLC-2000 Access System Circuit Packs
Pack
SMU
LAN
PDC
MDC
T8U *
PTU
* The T8U is required for TR-08 operation only.
Circuit Pack Verification
Step 1: Verify that the SMU, LAN, and PDC are in the ARM shelf.
Step 2: Verify that the MDC, T8U, and PTU are in the MDS shelf(ves) of the
subscriber circuits or drops to be tested.
NOTE
The T8U is required for TR-08 operation only.
Step 3: Verify that the DLC software is as follows:
RT: R 3.02.01 or R 4.05.00 (or later)
Location
ARM Shelf System Memory Unit
ARM Shelf Link to Alarms and Networks
ARM Shelf Provisioning and Display Controller
MDS Metallic Distribution Controller
MDS TR-08 Unit
MDS Power and Test Unit
:
Description
Issue 1 November 1998 A3-9