Input Signal Selection - Maretron M-Power CLMD16 Configuration Manual

____________________________________________________________
There is a list of input signals available to be used to activate the various "Switching Elements"
these "Input Signals" consist of the following:
Signal Name
None Selected
Binary Event 1 through 12 Low
Binary Event 1 through 12 Float
Binary Event 1 through 12 High
Network Input 1 through 16
Logic Output 1 through 48
Latch Output 1 through 16
Toggle Output 1 through 16
Timer Output 1 through 16
Flash Output 1 through 16
Counter Active 1 through 16
Over Current Fault Ch 1 through 16
Ch 1 through 16 Tripped
Ch 1 through 16 Thermal Limit Hit
Discrete I/O 1 through 32
Breaker On 1 through 16

"Input Signal Selection"

Description
This connects the specified input to a constant Logic '0' value
The signal on binary event 1 through 12 is in the Low voltage
range
The signal on binary event 1 through 12 is in the Float voltage
range
The signal on binary event for the numbered channel is in the
High voltage range
The state of the signal on Network Input for the numbered
channel
The state of the output of Logic Element for the numbered
channel
The state of the output of Latch Element for the numbered
channel
The state of the output of Toggle Element for the numbered
channel
The state of the output of Delay Timer Element for the
numbered channel
The state of the output of Flash Element for the numbered
channel
The state of the output of Counter Element 1 through 16
An Over Current Fault has been detected on Channel 1 through
16
The circuit breaker for the numbered channel is tripped
The circuit breaker for the numbered channel has reached its
thermal limit
The discrete state I/O of the signal the numbered channel
The state of an Output Channel for the numbered channel
CLMD16 Configuration Guide Rev.1.1 5