Load Timer Sequencing - Maretron M-Power CLMD16 Configuration Manual

CLMD16 Configuration Guide___________________________________

Load Timer Sequencing

In this example there will be a sequence of 2 timed events using "Timer Elements" to start the
process of Priming, Pre-heating, and starting a Generator where these items must be handled
in a manner of sequence. First sequence being to "Prime" and "Pre-Heat" and last sequence to
"Start". The input used to start this sequence is "Discrete I/O 5" (Momentary Input) and called
"Gen Start". Each "Timer Element" will trigger an ECB / breaker output for each of the three
actions the Generator will need to start (Prime, Preheat, Start). The generator requires 5s to
"Prime", 10s to "Pre-Heat" and 4s to "Start".
Step 1:
Place desired Momentary Input (Discrete I/O 5) to start the "Timer Elements" for "Prime" and
"Pre-Heat". Add the output of the Pre-Heat "Timer Output" to another "Timer Element" where
the "Timer Element" has an "On Delay" equivalent to the time the "Pre-Heat" "Timer Element"
is set to (10s). Add the output of the "On Delay" "Timer Element" to the "Timer Element" that
will be used for the 4s "Start" signal.
36 CLMD16 Configuration Guide Rev.1.1