Navigation / Steaming / Anchor Lights Toggle Logic Using Two Momentary Input Signals - Maretron M-Power CLMD16 Configuration Manual

CLMD16 Configuration Guide___________________________________
Note:
Because a third party MFD using 127500 Load Controller PGN or any equipment running
Maretron's N2KView® software, by default, will have direct access to control the above-
mentioned ECBs (#1 & 2) the "Navigation Lights Logic" circuit shown here will only operate via
"Discrete I/O 1 & 2". The same "Navigation Lights Logic" behavior may be able to be replicated
inside the internal logic of the equipment having direct control accessibility (N2KView®) or if
this logic needs to be accessed by third party MFD, "Manual Mode" can be enabled severing
this direct control access. Combinatory "Logic Elements" can be inserted before the "Logic
Element 1" and "Logic Element 2" to add "Network Inputs 1 & 2" to the scheme enabling the
same "Navigation Lights Logic" behavior via "Network Inputs 1 & 2" as long as the signal is a
momentary type Input Signal. The mapping for this exact circuit would look as shown below:
Navigation / Steaming / Anchor Lights Toggle Logic using two
Momentary Input signals
This circuit configuration type operates Navigation lights and Steaming Light (Fwd Mast) using
one "Discrete I/O" input then Steaming Light (Fwd Mast) and Anchor light (Aft Mast) using a
second "Discrete I/O" input. When "Navigation Lights" "Discrete I/O" input is commanded both
"Navigation Lights" and "Steaming Light" (Fwd Mast) ECBs turn On. When "Anchor Light"
"Discrete I/O" input is commanded "Anchor Light" (Aft Mast) + "Steaming Light" (Fwd Mast)
ECBs turn On. When "Anchor Light" "Discrete I/O" input is commanded while "Navigation
Lights" ECB is On, the "Navigation Lights" ECB Output is turned Off and "Anchor Light" (Aft
Mast) ECB output turns On while "Steaming Light" (Fwd Mast) ECB stays On.
24 CLMD16 Configuration Guide Rev.1.1