Configuration Of Common Circuit Types; Applying A Physical Momentary Or Sustained Contact Input Signal To Switch A Load - Maretron M-Power CLMD16 Configuration Manual

____________________________________________________________

Configuration of Common Circuit Types

Applying a Physical Momentary or Sustained Contact Input Signal
to Switch a Load
Applying a single momentary or sustained contact input signal to CLMD16 in order for the ECB
output to replicate the input signal of "On" or "Off" is a one-step procedure. See following
process to apply inputs to the CLMD16 ECBs.
Step 1:
Apply "Input signal" to desired breaker / load output control or "ECB". In this example the Input
Signal is "Binary Event Low"
CLMD16 Configuration Guide Rev.1.1 15