Table of Contents
Advertisement
Remote Control
This section describes the remote control operation of the FOX II T/R DP 4K transmitter and
receiver, including:
•
•
The transmitter and receiver each have a front panel Configuration port, a USB mini-B
connector (see
3-pole captive screw connector (see
and IR connections
such as a computer running the HyperTerminal or DataViewer utility, or a control system to
make remote control of the transmitter and receiver possible.
The protocol for the serial ports is as follows:
•
•
NOTE: SIS commands and Product Configuration Software functions are
Simple Instruction Set Control
Host-to-Unit Instructions
SIS commands consist of one or more characters per field. No special characters are
required to begin or end a command character sequence. When a command is valid, the
unit executes the command and sends a response to the host device. All responses from
the unit to the host end with a carriage return and a line feed (CR/LF = ] ), which signals the
end of the response character string. A string is one or more characters.
Simple Instruction Set Control
Product Configuration Software
Configuration Port
on page 11). Either of these ports can be connected to a host device
9600 baud
•
1 stop bit
•
transmitter- or receiver-specific or may have different responses depending on the
unit connected. You must connect to the appropriate device for the command or
function to work properly or to get the expected response.
FOX II T/R DP 4K Transmitter and Receiver • Remote Control
on page 11) and a rear panel Remote RS-232 port, a
item F
item O
on page 7,
no parity
•
8 data bits
no flow control
RS-232
on page 10, and
17
Advertisement
Table of Contents
