Securing The Hdmi Connector - Extron electronics DTP2 T 211 User Manual

Securing the HDMI Connector

Follow these instructions to secure the input and output connectors to the transmitter and
receiver with the LockIt HDMI lacing bracket provided:
Plug the HDMI cable into the rear panel connection.
1
Loosen the HDMI connection mounting screw from
2
the rear panel enough to allow the LockIt lacing
bracket to be placed over it. The screw does not
have to be removed.
Place the LockIt lacing bracket on the screw and
3
against the HDMI connector, then tighten the screw
to secure the bracket.
ATTENTION:
•
•
Loosely place the included tie wrap around the
4
HDMI connector and the LockIt lacing bracket as
shown.
While holding the connector securely against the lacing bracket, tighten the tie wrap,
5
then remove any excess length.
Do not overtighten the HDMI connector
mounting screw. The shield it fastens to is
very thin and can easily be stripped.
Ne serrez pas trop la vis de montage du
connecteur HDMI. Le blindage auquel elle
est attachée est très fin et peut facilement
être dénudé.
1 1
3 3
4 4
3
5 5
DTP2 T/R 211 • Installation and Operation
2 2
10