Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
7.4.1 Dimensions and Technical Data
Item
For shaft
RS01-SS12x22
T = transmittable torque at Fax = 0.
F
= transmittable axial force at T = 0.
ax
T
= fastening torque of the screws.
A
D = external exposure tolerance.
7.4.2 Mounting
•
The shaft-hub clamping has to sit inside the bore by at least the clamp length (21 mm).
•
Slightly oil the shaft-hub clamping before mounting, do not use molybdenum disulphide
or fat.
•
Tighten screws opposite each other 180 degrees offset in several steps to tightening
torque T
•
By tightening the screws, the inner diameter is reduced and the outer diameter is
increased. This ensures a stable clamping of the outer receptacle.
7.5 Brake Kit
As an option, a brake can be mounted on the motor shaft. For this purpose, LinMot offers a complete brake
kit consisting of a base flange, brake flange and pneumatic holding brake.
The pneumatic holding brake is controlled by the servo drive. A valve is also required to open and close the
brake. The brake acts on the shaft and is released by means of compressed air.
Page 32 / 48
T
[Nm]
12 mm
24
(see above for details).
A
F
T
ax
A
[kN]
[Nm]
4
1.2
PR02-52
ENG
Material: Steel
D
Weight
[mm]
[g]
22H9
22
NTI AG / LinMot
Advertisement
Table of Contents
