Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
360°
NTI AG / LinMot
2. Mount flange base and shaft seal.
First insert the shaft seal into the groove of the flange and
then screw the flange firmly to the front.
3. Insert the brake.
Push the brake into the opening of the brake flange.
4. Fasten the brake flange.
The brake flange with the applied brake can be rotated
360° and positioned as required. Then fasten with 4
hexagonal screws.
Tightening torque: 10 Nm
5. Remove the mounting screw for the air connection.
If the motor shaft can be moved easily, the mounting screw
can be removed. The shaft is then clamped. Instead of the
mounting screw, a compressed air connection is now
made.
When pressure is applied, the brake is released and the
shaft can be moved again.
The air pressure for the brake can be controlled using the
LinMot servo drives and a valve.
Attention! Before the motor is moved, make sure that the
brake is completely vented!
The brake may only be applied when the motor is at a
standstill!
PR02-52
ENG
Page 35 / 48
Advertisement
Table of Contents
