Honda HHT25S Manual page 91

CAM PULLEY / CYLINDER HEAD COVER / LOWER CRANKCASE
4. Loosely tighten the two 5 x 20 mm and four 5 x 30 mm hex
bolts, and then tighten in the numbered sequence.
TORQUE: 6.4 N•m (5.1 ft•lb)
5. Wait for approximately 60 minutes after assembly before filling
with oil and starting the engine.
SHROUD
REASSEMBLY
Set the 5 x 75 mm bolts on the shroud. Take care not to allow the
bolt heads to protrude from the shroud when installing on the
cylinder block.
OIL TUBE
REASSEMBLY
1. Install the oil tube with the "UP" mark facing toward the
cylinder.
2. Install the D12 and D13 tube clips as shown. Do not
interchange the clips and make sure the tube and shroud do
not come into contact.
8-12
" UP" MARK
D13 TUBE CLIP
HHT25S•HHT35S
D12 TUBE CLIP