Download Print this page

Honda HHT25S Manual page 35

Hide thumbs Also See for HHT25S:

Advertisement

MAINTENANCE
7. When you have about 150 mm (6 inches) of line remaining,
press the lines into the two notches on the bottom of the spool.
This will hold the lines on the spool for reassembly.
8. Feed both line ends through the metal eyelets in the housing.
Be careful to keep both lines taut between the spool and the
housing.
9. Continue to pull both lines until the spool reaches the bottom of
the housing. The lines should snap out of the spool notches.
If you are not sure the lines have snapped out of the notches,
gently pull the spool away from the housing about 1/8 inch to
inspect the lines. If necessary, gently pull each line until you
hear it snap out of the notch.
10. Trim the lines so they are equal in length.
11. Install the spring and knob. Rotate the knob in the direction of
the arrow until hand tight.
3-6
HHT25S•HHT35S
NOTCHES
METAL
EYELETS (2)

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Hht35sGx25Gx35