Honda HHT25S Manual page 124

HHT25S•HHT35S
4. Adjust the handlebar so that it makes a right angle with the
frame pipe center line as viewed from the gear case.
5. After adjustment, secure handlebar holder C by tightening the
two 5 x 25 mm flange bolts to the specified torque.
TORQUE: 5 N•m (0.5 kg•m, 44 in•lb)
6. Adjust the handlebar so that it makes a right angle with the
frame pipe as viewed from the side.
7. After adjustment, secure handlebar holder A by tightening the
four 5 x 25 mm bolt/washers to the specified torque.
TORQUE: 5 N•m (0.5 kg•m, 44 in•lb)
HANGER HOLDER INSTALLATION
Position the hanger holder at the location shown, and then tighten the
5 x 20 mm pan head screw to the specified torque.
TORQUE: 3 N•m (0.3 kg•m, 27 in•lb)
FRAME ASSEMBLY / HANDLEBAR
FRAME PIPE
5 x 25 mm
BOLT/
WASHER (2)
HANDLEBAR
HOLDER C
HANDLEBAR HOLDER A
90°
HANGER
HOLDER
5 x 20 mm
PAN HEAD SCREW
3 N•m (0.3 kg•m,
27 in•lb)
90°
HANDLEBAR
HOLDER B
ENGINE
MOUNTING
BRACKET
220 mm
(8.7 in)
11-9